40L Lab Top-mounted Electric Overhead Stirrer Digital Mixer Variable Speed NEW

Description

Top-mounted electric agitator, DC permanent magnet motor, low noise, maintenance-free. Smooth start, overload protection, loop protection, adjustable speed, precise and controllable.
Features:
1. Competent for high load
Can work continuously for a long time, outstanding performance.
2. The condensation clamp is wrapped in rubber
The condensation clamp is wrapped with rubber, which increases the friction and effectively clamps the vessel. The torque can be adjusted automatically according to the change of sample viscosity.
3. High and low speed, accurate and controllable
The LCD displays the set value and actual value of the speed, and can monitor the speed and time in real time. The speed range is wide 200-3000rpm, constant speed, high and low speed can be accurately controlled.
Range of use:
It is a good tool for petroleum, chemical industry, metallurgy, textile, food, medicine and health, environmental protection, biochemical laboratory, analysis room, education and research.
parameter:
Large mixing capacity (H, O): 40L
Motor input power: 120W
Motor output power: 100W
Mixing machine power: 130W
Voltage: 100-240V
Speed: 200-3000rpm
Speed display: LCD
Variable speed: 20rpm
Torque: 60 (N / CM)
Overload protection: automatic stop
Maximum viscosity [MPAS]: 50000
Drilling chuck clamping diameter range [VAC]: 0.5-10
DIN EN60589 protection method: IP42
Allowed ambient temperature [° C]: 5-40
Allowed ambient humidity [%]: 80
Steps:
Press and hold the right button to boot, press the set button to select the setting
① Press the set button once, the mode flashes, press the upper and lower two buttons in the middle to select the mode, a total of three modes corresponding to different speed and time.
②Select the mode mode, press the set button again, Rpm flashes and use the up and down keys to set the required speed per minute.
③ After setting the speed, press the set key, Min flashes, use the up and down keys to set the required timing time, after starting, the speed reaches the set speed, and the timing starts timing.
④ Set the above parameters in a certain mode, long press the set key, the screen flashes, indicating that it has been stored in this mode, the next time you only need to select mode to correspond to the set speed and time, press the right button Start and pause, long press the key
Shut down.
Package includes:
1 * Host
1 * Stirring rod
1 * pillar
1 * Thick base
On Jun-15-21 at 08:07:08 PDT, seller added the following information: